How to Use the ApneaLink Air
The ApneaLink Air is comfortable and easy to use. Install the batteries and put the chest belt, finger sensor and cannula in place, and start the device. In the morning, return the device using the prepaid envelope.
3分钟
Setup time: Put the batteries and sensors in place and start the device
1 night
在你自己的床上
FDA
Approved device
返回
使用预付信封
你使用的是哪款设备？
Select Your Device for Specific Instructions
逐步指南
7 Simple Steps
Install the Batteries
Make sure the + sign on each battery aligns with the + sign in the compartment.
The batteries are included in the packing envelope.
Place the Belt Around Your Chest
Place the belt around your chest with the device resting on your chest.
For women, placing the belt above the breasts rather than over or below them may be more comfortable.
Place the Nasal Cannula
Place the nasal cannula under your nose. Place the two prongs face down at the entrance to your nostrils. Loop the cannula over your ears and tighten it under your chin to a comfortable snugness. Plug the other end of the cannula into the device, turning clockwise to tighten.
If you're an active sleeper, secure the cannula to your cheeks using the medical tape supplied.
Place the Finger Probe
Place the finger probe onto your index finger of either hand. The line or wire on the finger cap goes on top of your finger. Secure the line to the back of your wrist using the medical tape supplied. In the middle of the line there is a recorder partially made of purple plastic. Clip the recorder over the belt.
The system is now fully assembled.
Start the Device
Start the device by pressing the on-off button in the middle of the device for 2 seconds. The central light will turn green, and after a few seconds the 3 lights in the corners will turn green also. If any light blinks red, check the connections.
Once all lights are green, you can go to sleep as you normally do.
Turn Off in the Morning
In the morning, turn off the device by pressing the on-off button for 3 seconds. The central light will turn off. If the "test complete" light turns green, you have successfully completed the test.
If the light is red, call Advanced Sleep Medicine Services at (877) 775-3377 and we will help you troubleshoot.
Return the Device
Return the device using the prepaid envelope. Put the device into the envelope and seal it. Drop the sealed prepaid envelope into the parcel slot at your local post office.
Please return the device the morning after your test so we can process your results as quickly as possible.
Your Kit
信封里装的是什么？
睡眠监测设备
Records breathing & oxygen all night
2 AA batteries
New batteries wrapped in plastic
Nasal cannula
New cannula in a separate plastic bag
Finger pulse oximeter
Clips onto your index finger on either hand
Chest strap / belt
Measures breathing effort
患者须知
附带图解的详细说明
Prepaid return envelope
Prepaid and pre-addressed. Just drop it at the US Post Office.
最佳实践
注意事项
做
- 为了达到最佳效果，每晚至少睡4-6小时。
- 保持正常的睡姿和睡前习惯。
- 按时服用任何常规处方药物
- 如果您感到任何不适或不清楚的地方，请随时联系我们。
- Mail the device back to us the morning after the test
不
- 检查当晚请使用您的PAP设备（除非您的医生另有指示）。
- 考试当晚请饮酒
- 服用安眠药、抗组胺药或镇静剂
- 考试前一天要充分午睡
- Use heavy lotions on your hands (affects the finger sensor)
- 如果夜间醒来，请取下传感器。
常见问题